Before you start
- Mow the lawn short with a regular mower.
- Clear sticks, stones, toys and hoses.
- Check Wi-Fi or mobile signal across the lawn if your model needs it.
Wire-free setup
Pick the dock spot
Flat, on the lawn edge, near a power outlet, with open sky for RTK models. Leave clear space in front.
Install the antenna (if needed)
Some RTK models need a reference antenna mounted high with a clear sky view. Network RTK models skip this.
Connect the app
Pair the mower, update firmware and connect to Wi-Fi.
Map the boundary
Drive the mower around the edge with the app's joystick. Go slowly and keep wheels on the grass.
Add no-go zones and channels
Mark ponds, beds and play areas. Draw channels between separate lawns.
Set schedule and height
Start a bit higher, then lower over a few weeks.
Wired setup
Plan the wire route
Follow the maker's distances from edges, paths and walls.
Peg or bury the wire
Pegs work and grass grows over in weeks. Burying a few cm protects it from scarifiers.
Add guide wire and islands
Guide wires help it find the dock; islands go around beds and trees.
Connect to the dock and test
Run the setup routine and watch the first edge pass.
Most setup problems come from docks in shady spots (RTK) or wires too close to edges. Also set a PIN and enable alarms. See theft protection.
Frequently asked questions
Should I mow before setting up a robot mower?
Yes. Cut the lawn to a normal height first. Robots are designed to maintain short grass, not cut long grass down.